Walk-in shower installation in Burlington, NC
A walk-in shower opens up a bathroom, simplifies cleaning and makes bathing easier. How it is built decides whether it stays that way.
Why people choose a walk-in shower
Some want the open look of glass and tile. Some are tired of stepping over a tub wall. Some are planning ahead for the years when balance and strength change. A walk-in shower serves all three reasons, and it is one of the most requested bathroom projects we hear about.
The word covers several designs, from a standard alcove with a low threshold to a fully curbless floor that flows from the bathroom into the shower. Each has different needs, so the first step is deciding which one suits the room.
Types of walk-in showers
- Low-threshold alcove: a small curb, simple and economical.
- Curbless shower: floor slopes from the room to the drain with no step.
- Shower with a fixed glass panel and open entry, no door.
- Corner or full-width layouts depending on available space.
- Showers with a bench, niche and handheld sprayer.
What goes on behind the tile
The pretty part of a shower is the tile. The important part is what is behind it. A proper build has a sloped base that leads to the drain, a waterproof layer that covers the floor and walls, and tile set on a stable surface. Corners, seams and the drain connection get extra attention because that is where leaks begin.
We explain each layer before work begins, so you know what is being built and why. If you want more detail, read why shower leaks start behind the tile.
How the project runs
- Remove the tub or old shower and inspect the floor and walls.
- Repair framing or subfloor if needed and move plumbing if the layout changes.
- Build the sloped base and install the drain.
- Waterproof the floor and walls.
- Set tile, add the bench and niche, and grout.
- Install the valve trim, showerhead and glass.
- Test the shower and clean up.
Glass, fixtures and finishes
Frameless glass looks clean but needs careful installation and sealing. Framed glass is more economical. Open designs without a door need enough space so water stays inside. Fixtures vary from a basic showerhead to a combination of rain head and handheld. Choose slip-resistant floor tile and keep grout lines manageable for easy cleaning. See shower door and faucet installation.
Replacing a tub
Most walk-in showers in existing homes replace a tub. That changes the footprint, the drain location and sometimes the wall framing. Our tub-to-shower conversion page walks through the steps and what affects cost. Call (336) 654-1130 and we will look at your bathroom and tell you what is possible.
Choosing size, glass and layout
Shower size affects comfort more than almost anything else. A shower that is too tight feels like the tub you replaced, while one that is generous makes the bathroom feel larger. We measure the available space and draw a few layouts, including where the door or opening goes, where the valve sits and whether a bench fits.
Glass is the other big decision. A fixed panel with no door is simple and open but needs enough depth to keep water inside. A hinged or sliding door contains spray more reliably. Clear glass keeps the bathroom bright, while frosted glass adds privacy. We help you weigh these with the room and your habits in mind.
Questions we hear on the phone
Short answers to what callers ask most. Call if yours is not here.
Is a curbless shower hard to build?
It takes careful floor framing and waterproofing, but it is a well-understood job.
Do walk-in showers leak onto the floor?
A properly sized shower with the right glass and slope keeps water inside.
Can a walk-in shower fit where my tub is?
Usually yes. The tub footprint is a common size for a shower.
What tile works best?
Slip-resistant tile on the floor and larger tiles on walls for fewer grout lines.
Related services
Tell us about your project.
Call and we will schedule your estimate.